Publicidad
IV. EV Charger Mounting
Removing the decorative cover
1. Remove the bottom screw (A) on the flat
workbench.
2. It is recommended to start at the bottom of
enclosure (C) when removing the decorative
cover (B).
1
Inserting the upper mounting
screws
1. Install the upper mounting screws (A) in the upper
holes (B). The recommended torque is 4.4 Nm.
2. Ensure the screw protrudes at a length X out from
the wall. The length of X is recommended to be 3
mm (0.12inch).
3
ENGLISH
Drill three Φ10 mm holes at a
depth of approximately 70 mm for
the mounting screws
1. Hold the installation template (A) against the
wall and ensure the installation is level by using a
spirit level.
2. Mark the location for the three mounting holes
(B).
3. Drill three mounting holes (B).
4. Insert the wall plugs (C) into the mounting
holes (B).
2
Installing the EV charger on the
wall
1. Place the openings (A) over the upper mounting
screws (B).
The upper mounting screws support the EV charger.
4
3
Publicidad
