Princess 01.341500.01.001 Manual De Usuario página 4

Instruction manual
• Do not use this heater in the immediate
surroundings of a bath, a shower or a swimming
pool.
• Joists, beams and rafters shall not be cut or
notched to install the appliance.
• Please do not install the appliance close to
curtains and other combustible materials. This
could cause a fire.
• The appliance shall, under no circumstances,
be covered with insulating material or similar
material.
• The heater must not be located immediately
below a socket-outlet.
• Do not use this heater if it has been dropped.
• WARNING: The heater must not be used if the
glass panels are damaged.
• Use this heater on a horizontal and stable
surface, or fix it to the wall, as applicable.
• WARNING: Do not use this heater in small
rooms when they are occupied by persons not
capable of leaving the room on their own,
unless constant supervision is provided.
• WARNING: To reduce the risk of fire, keep
textiles, curtain, or any other flammable material
a minimum distance of 1m from the air outlet.
4
• The heater needs to be installed so that the
switches and other controls cannot be touched
by a person in the bath or shower.
Installation
Foot assembly
• Before using the heater, the feet must be fitted
to the unit. (image 1)
• These are to be attached to the base of the
heater using the 8 ST4x12mm screws provided.
(image 2)
• Take care to ensure that the feet are located
correctly on the bottom end of the heater.
• The heater should stand vertically once the feet
are installed (image 3). If the heater tilts
backwards then please remove the feet and
rotate them before fitting again. (image 4)
Wall mounting
• Demount the bracket from the back of the
device, by loosening the screws.