ulsonix ASHCLEAN 20B 18V Manual De Instrucciones página 20

2. Attach the filter set to the bottom of the cover.
3. Place the cover with the installed filters in the container and close the hinges.
4. Install the battery in the battery compartment on the device cover.
5. Connect the aluminum end with the soft suction hose. Insert the other end of
the suction hose into the air inlet.
THE BLOW FUNCTION
1. Connect the aluminum end with the soft suction hose. Insert the other end of
the suction hose into the air outlet.
3.3. Device use
1. Switch the device on with the ON / OFF button.
2. Vacuum the ash directly from the fireplace or stove using the aluminum tip.
3. Press the ON / OFF button to switch off the vacuum cleaner.
VACUUMING THE ASH
• Always use a heat-resistant filter when vacuuming ash.
• When the container is full, empty it.
• If the suction power decreases, the vacuum cleaner does not pick up any more
ash and the container is empty, remove and clean the filter.
• When vacuuming ash from the fireplace, the ash temperature must be below
40 ° C. Ashes that are still glowing should not be vacuumed!
AFTER USE
1. Press the ON / OFF button to turn off the vacuum cleaner.
2. Disconnect the suction hose from the machine.
3. Pull the battery out of the device.
4. If necessary, charge the battery with the charger.
5. Remove the cover from the device.
6. Empty the dirt from the container and wash it.
7. Dry the container thoroughly.
8. Remove the filter, clean its outside of coarse dirt and wash the filter
thoroughly under running water (direct the stream of water only from the
inside of the filter!).
9. Before reinstalling the filter, dry it thoroughly.