WKM PSC-2300W.17 Manual De Instrucciones página 10

- Detach the dust container (g) by tuning it counter-clockwise.
- Hold the HEPA filter (i) and remove it by turning it counter-clockwise.
- Remove the filter cover (e) and clean it free from any deposits.
- Clean the HEPA filter (i) and wash it, if necessary.
- The HEPA filter is for strengthening the filtration effect, it needs to be cleaned and washed
after being used of a period of time.
- Before turning on the device or reinstalling the dust container (g), check that the HEPA
filter (i) and its filter cover (e) are installed correctly.
- Do not use the device if one filter or both filters are not properly installed.
- The HEPA filter can be sashed in cold water.
Note: Ensure that the HEPA filter is completely dry before assembling the appliance.
How to clean the air filter
- Open the door of the filter compartment, lever the small flap.
- Wash it with cold water.
Note: After cleaning, always ensure that the filter is completely dry before replacing it.
How to clean the appliance
- Clean only with a dry or slightly damp cloth or neutral detergent. do not let the vacuum
cleaner get wet.
Specification
Voltage: 220-240V~ 50/60Hz
Power: 850W
Waste Management
The symbol above and on the product means that the product is classed as
Electrical or Electronic equipment and should not be disposed with other
household or commercial waste at the end of its useful life.
The Waste of Electrical and Electronic Equipment (WEEE) Directive
(2012/19/EU) has been put in place to recycle products using best available recovery and
recycling techniques to minimise the impact on the environment, treat any hazardous
substances and avoid the increasing landfill. Contact local authorities for information on
the correct disposal of Electrical or Electronic equipment.