WKM PSC-2300W.17 Manual De Instrucciones página 9

How to use the cyclone vacuum cleaner
CAUTION: Do not operate the product until it is properly assembled.
1. Take out the appliance from the box and remove its internal and external packaging.
2. Insert the click connector (o) of the flexible hose into the flexible hose tie-in (m).
3. Install the suction pipes (p) according to the desired length.
4. Insert the handle with suction power control (q) at the end of the suction pipe (p).
5. Fit the desired accessory to the other end of the suction pipe (p).
6. Unwind all the cable and when the appliance is switched off, plug it into a power outlet.
7. Press the ON/OFF button (b) to switch on the appliance.
8. To switch off the appliance, please press the ON/OFF button.
9. The suction can be adjusted manually by using the suction power control located on the
handle (q).
10. To rewind the power cable (s), press the rewinding button (c).
11. Note: check the cable while rewinding it. Rewinding the cable too fast may damage
objects or injure people.
12. To disconnect click connector (o) of the flexible hose from the flexible hose tie-in (m),
press and hold the button on the click connector (o).
13. After use, please empty the dust container (g).
14. Clean the filters: HEPA filter (i) and air filter (k).
Care and Maintenance
WARNING: Always ensure that the product is unplugged from the electrical outlet before
moving, assembling, disassembling, or cleaning.
- Clean the filters each time you use the appliance and if necessary replace them.
- Do not use the appliance if the filters are damaged, worn or missing.
- Never use inflammable or corrosive liquids, which could seriously damage the appliance,
other objects and injure people.
- Do not use soap to wash the filters.
- Do not use hot water to wash the filters.
- Please check that there is no foreign object in the tubes.
- Store the appliance in a dry and clean place.
How to empty the dust container
- Remove the dust container (g) by pulling the handle (f) and pushing the dust container
release button (h).
- To discharge the dust, please unlatch the dust container (g) by turning it clockwise.
- After discharging the dust, check that the dust container (g) is replaced correctly before
placing it on the device.
How to clean the HEPA filter
- Press the dust container release button (h) and pull the handle to remove the dust
container (g).