Publicidad
Idiomas disponibles
Idiomas disponibles
PARTS
Front
Vane
Control panel
Remote control receiver
Swivel base
Back
*Demonstrated model is PCF-HE18R
Control panel
Air flow strength indicator
Power/air flow strength button
Front guard
Main body
Rear guard
Handle
Motor (Internal)
Remote controller storage area
Power plug
Power cord
Timer indicator light
Timer button
Oscillation button
5
REMOTE CONTROL
*Remove the protective film from the battery before use .
Power button
Product will begin operating on
the last setting used .
Press the button during
operation to turn the product off .
Air flow strength button
Press the button to select desired
air flow during operation .
Changing out the battery
Replace the battery with a CR2025 battery when the product takes a long
time to respond or stops responding when the operation buttons are pressed .
1. Pull out the battery holder.
Hold the claw in to close the gap and pull the holder out .
2. Insert a new battery.
Insert a new battery into the battery holder . Make sure the battery is
facing the correct direction . Insert the battery holder back into the remote
control .
•
Pay attention to which side is front and which is back .
•
Dispose battery according to the disposal recommendation on the
battery packaging or proper governmental regulations .
Improper handling of the battery can lead to
battery rupture, leaking battery liquid, and
Attention
damage to the surroundings . Read the 'Remote
use' section of the safety precautions before
use .
Remote control
To use the remote, point the infrared
sensor at the remote receiver on the
front of the main body .
Timer button
Press the button to choose the
desired run time . To clear off the
timer, press the button again .
Oscillation button
Horizontal Oscillation button . Press
the button to turn the left and right
oscillation on or off .
Claw
Back
①
②
Hold and pull it out
Battery holder
up
(Positive side is up)
6
Publicidad
