VITO Pro Power VIMP710 Manual De Instrucciones página 16

EN
WARNING: Disconnect the
plug from the power source before
making any assembly, adjustments
or changing accessories.
Such preventive safety measures
reduce the risk of starting the
tool accidentally.
1. Dust cap
2. Locking sleeve
3. Release button
4. Mode selector switch (drill stop)
6. On/of switch
7. Auxiliary handle
8. Clamp screw
9. Depth gauge
INTEND USE
The tool is intended for hammer
drilling in concrete, brick and stone
as well as for light chiseling work.
It is also suitable for drilling without
impact in wood, metal,
ceramic and plastic.
SWITCHING ON AND OF
Warning: before plugging the
tool, always check to see that the
switch trigger actuates properly
and returns to the of position when
released. Fig.2
To start the tool, press the on/of
switch (6) and keep it depressed.
To switch of the tool, release the on/
of switch (6). For low temperatures,
the tool reaches the full hammer/
impact capacity only after a certain
time. This start-up time can be
shortened by striking the drill/chisel
against the foor one time.,
16
OVERLOAD CLUTCH
If the tool insert becomes caught
of jammed, the drive to the drill
spindle is interrupted. Because of
the forces that occur, always hold
the power tool frmly with both
hands and provide for a secure
stance. If the power tool jams,
switch the tool of and loosen the
tool insert. When switching the tool
on with the drilling tool jammed high
reactions torques can occur.
WARNING: As soon as the
power tool jams, switch the tool of
immediately. This will help prevent
premature wear of the tool.
MODE SELECTOR SWITCH
Operate the mode selector switch
only when the tool is at a standstill.
This will help prevent premature
wear of the tool.
HAMMER DRILLING
For drilling in concrete, masonry,
etc, depress the release button (3)
and rotate the mode selector switch
(4) so that the pointer points
to the symbol.
CHISELING
For chipping, scaling or demolition
operations, depress the release
button (3) and rotate the mode
selector switch (4) so that the
pointer points to the symbol.
WARNING: The mode selector
switch (4) must always be locked
in the chiseling position when
chiseling.
DRILLING
For drilling in wood, metal or plastic
materials, depress the release
button (3) and rotate the mode
selector switch (4) so that the
pointer points to the symbol.