Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Machine Setup
This sanding machine is designed to be operated with a 1-1/2" remote
vacuum dust collection system.
Preparing Remote Vacuum Dust Collection Systems
To prepare the machine for remote vacuum dust collection system that have a 1-1/2"
hose end, connect vacuum hose to dust elbow on machine (Figure 4).
WARNING! Only operate machine connected to a functioning vacuum system.
Failure to do so will create a dusty environment and could result in dust inhalation.
NOTE: Start the remote vacuum collection system before operation.
Preparing the Machine for Operation
1. Familiarize yourself with machine. Read all danger, warning, and
caution statements and the Owner's Manual before operating this machine.
2. The machine will only accept hook and loop abrasive discs. When installing
abrasive disc, take care to center disc on driver (Figure 5).
FIGURE 4
Figure 4
SANDING DISC
Figure 5
8
EN
Operating Instructions
1. Move machine to the location of your work. Set any exposed
nails with hammer and punch to avoid encounter with abrasive.
2. Adjust angle by rotating Head Index Latch upward (Figure 7).
Position handle in desired location (180 Degrees total rotation).
3. Make sure the control switch is in the "OFF" position then
connect the power cable to an appropriately grounded fused
circuit. Connect the power cable to the Power Cord Receptacle
(Figure 1).
4. With the machine in the reclined position move the ON/OFF switch
to the "ON" position (Figure 1).
5. Energize the Sanding Disc by pressing and releasing the
red start button.
6. Stop the machine by switching the ON/OFF Switch to OFF.
7. Gradually lower pad to surface intended for sanding. Make sure the
machine is in motion while the pad is engaged with the surface to
be sanded. It is advisable to not add effort to the pad as this may
lead to "nosing in" or "tipping" which produces grooves or lines on the surface.
8. When replacing abrasive, emptying the contents of the dust bag,
or when sanding operation is completed, return machine to reclined
position, flip ON/OFFswitch to "OFF" then disconnect the power cable
from the Power Cord Receptacle.
9. Empty remote vacuum dust bag whenever it becomes 1/3 full.
UNLOCK
LOCK
Figure 7
DANGER:
Failure to disconnect the power cable from machine
whenever servicing, replacing abrasive, or emptying the dust bag could
result in electrocution or severe injury. Never leave machine unattended
while the power cable is connected.
DANGER:
Never leave vacuum unattended with sanding dust
in it. Sanding dust can spontaneously ignite and cause a fire or explosion.
Empty vacuum into a metal container, clear of any combustibles. Do not
empty dust contents into a fire. Do not overfill vacuum.
9
Publicidad
