Publicidad
Idiomas disponibles
Idiomas disponibles
the power tool before making any
adjustments, changing accessories, or
storing power tools. Such preventive safety
measures reduce the risk of starting the power tool
accidentally.
d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of untrained
users.
e) Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any other
condition that may affect the power tool's
operation. If damaged, have the power
tool repaired before use. Many accidents are
caused by poorly maintained power tools.
f)
Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to be
performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.
5) Service
a) Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This will ensure
that the safety of the power tool is maintained.
TRIMMER SAFETY
WARNINGS
–
Hold power tool by insulated gripping surfaces,
because the cutter may contact its own cord. Cutting
a "live" wire may make exposed metal parts of the
power tool "live" and shock the operator.
–
Use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding
the work by your hand or against the body leaves it
unstable and may lead to loss of control.
–
Always wear dust mask.
12
SYMBOL
To reduce the risk of injury, user must read
instruction manual.
Double insulation
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Make sure the tool is unplugged prior to
changing accessories.
Before working with your tool make sure that
no power cords will be damaged.
OPERATION
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended use
The tool is intended for routing grooves, edges, profiles and
elongated holes. It is also suitable for copy routing in wood,
plastic and light building materials, while resting firmly on
the workpiece.
INSTALLATION AND ADJUSTMENT
Installing a cutting bit
(1) Release and remove the depth adjustment cover by
opening the locking lever (6). (See Fig. A1)
(2) Press the spindle lock button (7) and slowly rotate the
spindle by hand until it locks in place. Use the included
wrench (15) to loosen the clamping screw (b) (8) on the end
of the spindle. (See Fig. A2)
(3) Insert the bit into the spindle collet. (See Fig. A3)
(4) Tighten the clamping nut (b) (8) to secure the bit in the
EN
Publicidad
