Wilfa GLACIER Manual De Instrucciones página 11

CONTROL PANEL
1. Plug in power cord, the machine is in standby mode, and the small ice
indicator light flashes green. Press the START/PAUSE button, the indicator
lights of small ice and large ice flash alternately. When the corresponding
indicator lights up, press the START/PAUSE button again to choose size, and
the machine starts to work. The corresponding indicator lights up for a long
time, and the ice cube production starts.
2. CLEANING FUNCTION: Plug in power cord, press the START/PAUSE button
to start the machine, and then press the START/PAUSE button for 2 seconds.
The machine enters the cleaning function, and the four lights flash alternately.
Do not disconnect the power supply during cleaning. After cleaning, the
machine will automatically enter the standby mode.
3. ADD WATER: When the "Add water" indicator light is on, it means that the
water tank is empty. Add water and press the START/PAUSE button to restart
the machine.
4. ICE FULL: When the ice reaches the maximum amount of ice storage
container, the ICE FULL indicator light is on and the machine stops. Remove
the ice cubes. When the ice position is lower than the full sensor position, the
machine will restart automatically.
ICM1-600 · GLACIER
ICE FULL: Ice full alarm indicator light
ADD WATER: Water shortage alarm indicator light
CLEAN: Large ice indicator light
ICE MAKING: Small ice indicator light
9
EN