Wilfa GLACIER Manual De Instrucciones página 12

HOW TO USE
EN
1. Open the lid and take out the ice collecting tray and add water to the
container. Note: There is a maximum water level indicator in the container.
The water should not exceed the level indicator. If the water exceeds the
maximum line, you need to open the bottom drain plug, release the excess
water, and close the lid.
2. Plug in power, press the START/PAUSE button to start the machine.
IMPORTANT
• For the three first cycles, the ice produced is small and irregular.
• When the ice collecting tray is full, please take out the ice immediately, do not
let the ice overflow the ice collecting tray.
• If the compressor does not work due to lack of water, ice full, power failure,
etc, it will delay for 3 minutes to start up after restarted.
CLEANING
1. Unplug the appliance after using or before cleaning.
2. Clean regularly surfaces that can come in contact with food and accessible
drainage systems.
3. Clean the inner liner, ice collecting tray, water tank and ice scoop frequently.
When cleaning, unplug the unit and remove the ice cubes. Use a diluted
solution of water and vinegar to clean the inside and the outside surface of
the Ice maker. Rinse thoroughly before use.
4. After being idled for a period of time, the ice cube maker may not be able
to pump enough water up for air blockage. In this case, the water shortage
indictor light is displayed, just press START/PAUSE button to restart the ice
maker.
5. To ensure the cleanness of ice, please change the water at least once one day.
If you do not use it for a long time, please drain the water out and clean it.
6. If the refrigerating appliance is left empty for long periods, switch off and
leave the door open to prevent mold developing within the appliance.
INSTRUCTION MANUAL · ICE MAKER
10