Proline KTEA2 Manual Del Usuario página 35

In order to remove any dust or protective residues from the manufacturing
process, it is recommended to run a boiling cycle then discard the water.
1. Remove and discard any packing materials, promotional labels and tape from
the appliance.
2. Lift the jug lid handle to pull the jug lid assembly out of the jug and then
remove the tea basket from the jug lid assembly.
Remove the tea basket by holding the tea bas-
ket lid with one hand and turning the basket
clockwise.
3. Wash the jug lid assembly and tea basket in warm soapy water with a soft
sponge, rinse and dry thoroughly.
power plug in water or allow moisture come in contact with these parts.
4. Place the power base on a flat, dry surface.
5. Without the tea basket in place, fill the jug with water up to the maximum
mark (1.7L) and then fit the jug lid onto the jug.
6. Place the jug onto the power base and then plug the power base into the
mains socket.
7. Press
• The applianc will start the boiling cycle at 100°C temperature.
• The indicator lights around the 100°C button and the button
illuminate.
8. Once the water reaches 100°C, the appliance will beep twice and the
indicator lights surrounding the 100°C button and the
9. Discard the water. The tea maker is ready to use.
KTEA2_IB.indd 33 KTEA2_IB.indd 33
BEFORE FIRST USE
NEVER immerse the base of the jug, the power base, power cord or
.
will
button will go out.
33
17/11/2021 15:59 17/11/2021 15:59