Beper P102CON550 Manual De Instrucciones página 10

Ice Machine Use Instructions
Product description Fig.A
1. Lid
2. Main unit
3. Air intake
4. Maximum water level
5. Ice collector basket
6. Silicone cap for water leakage
7. Ice scoop
8. Ice basket full indicator
9. Operation indicator
10. Out of water indicator
11. ON /OFF button
12. Large ice indicator
13. Large / small ice selection button
14. Small ice indicator
Instructions for Use
Make sure that the silicone cap for water leakage placed under the product is tightly closed.
Open the lid, remove the ice collector basket and insert water without exceeding the maximum level, indicated
by the word MAX.
Reinsert the ice collector basket making sure it is properly installed.
Press the ON / OFF button to turn on the product, the operating indicator will light up. Using the selection key,
select the size of the ice: the relative indicator will light up on the selected size.
The first ice production cycle takes about 8 minutes: the duration depends on the ambient and water temperature
as well as on the size of the ice selected.
The ice cubes will take 3-4 cycles to reach the correct size selected. Therefore, if you switch from small to large
cubes, it will take 3-4 cycles to have larger cubes.
Once the product has been operated, periodically check the residual water level. If the level is too low and the
pump fails to draw water, the machine switches off automatically and the empty water indicator turns on. Add
water and turn the product back on to make more ice.
If the ice collector basket is full, the machine stops producing ice and the ice basket full indicator turns on. Empty
the basket to resume making ice.
To stop ice production, press the ON / OFF button and the product will go into stand by mode.
It is recommended to change the water every 24 hours to keep the water clean.
If you do not use the product for a long time, drain the water by opening the silicone cap placed under the base
of the machine, so that all the water comes out. Then clean the water tank with a cloth.
Cleaning
It is recommended to clean the product before proceeding with the first use.
Make sure that the plug is disconnected from the electrical outlet, remove the ice collector basket and open the
silicone cap placed under the base and drain all the water.
Clean the water tank and the outside of the product with a damp cloth and dish detergent.
Do not use aggressive detergents such as alcohol and / or abrasive tools.
Rinse with clean water and dry.
Reinsert the silicone plug and make sure it is firmly fixed.
Self-cleaning function
To start the self-cleaning function, press and hold the ON / OFF button for three seconds.
The basket full and water out indicators will start to turn on alternately and the pump starts sucking water by
pouring it into the basket, following this process for about 10 times. Once the self-cleaning process is finished,
the product goes into standby.
10