Beper P102CON550 Manual De Instrucciones página 11

Ice Machine Use Instructions
Frequent problems
Problem
The product makes an abnormal
sound
The basket full indicator is on but
there is no ice
The water out indicator is on but
the tank is full of water
Ice has impurities
Ice smells
The water out indicator is on
The basket full indicator is on
The operating indicator flashes
The ice cubes stick together
The drum is full but the drum
indicator does not come on
The product works but does not
make ice
Technical data
Power: 100W
Power supply: 220 - 240V 50 Hz
Refrigerant: R600a / 18 g
Climate class: SN / N / ST
Nominal cooling current: 0.7A
For any improvement reasons, Beper reserves the right to modify or improve the product without
any notice.
Possible cause
The product is not on a stable
surface
The voltage is too low
There is a foreign body in the fan
The infrared sensor detects a
foreign object
The infrared sensor is broken
The pump is broken
The water collection system is
blocked due to impurities
There are impurities in the water
First use
Low quality water
There is no water
There is too much ice in the
basket
The panel that pushes the ice
towards the basket is blocked
The ice making cycle is too long
Too many parts are submerged
in water
The water temperature is too
cold
The product is positioned in too
strong a light that does not allow
the infrared to work properly
The compressor is in start-up
protection or there is a refrigerant
leak.
11
Solution
Install the product correctly
Check the voltage
Unplug and check the fan for
foreign objects
Unplug and remove the foreign
object
Contact support
Contact support
Clean the water tank and use
clean water
After a few uses the bad smell
disappears
Fill in more water and turn on the
product
Empty the basket
Turn off the product and contact
assistance
Turn off the product and after the
ice has melted turn it back on
Arrange the evaporator
Change the water and insert it
at a temperature between 5 and
32 ° C
Move the product more in the
shadow
Turn the product off and on for
a few times and unplug it. Try
turning the product on again after
30 minutes and it should work. If
it does not start working again,
contact assistance
EN