Miltenyi Biotec MACSxpress Manual Del Usuario página 19

4
Operate the instrument
4.1 Charge the instrument
Overloading of batteries can lead to leakage of battery fluid.
• Only use the included power cable.
1
Before using the MACSxpress Separator fully charge the integrated NiMH
battery.
2
Connect the MACSxpress Separator to the power supply using the
provided cable (refer to
3 Plug the power supply into an appropriate electrical outlet. The LED on
the MACSxpress Separator indicates the battery charge status (
4
After charging, unplug the power supply from the electrical outlet.
5
Disconnect the MACSxpress Separator from the USB cable and re-attach
the blind plug to the USB port.
LED status
Green, blinking while charging
Green, permanent on while charging
Red, flashing while light is on
Table 4.1
: Overview of battery charge status.
4.2 Switching the light on or off
1
Press the button labeled
2
The light will turn off automatically after 4 minutes.
3 Alternatively, press the button again for a few seconds to switch off the light.
Assemble the instrument on page 16
Battery charge status
Battery is being charged.
Battery is fully charged.
Battery power is low.
IO
for a few seconds to switch on the light.
).
Table 4.1
).
4
17