Publicidad
Step 12
Fasten two DRAWER FRONT MOLDINGS (I) to a
å
DRAWER FRONT (H). Use four BLACK 1-1/4" FLAT HEAD
SCREWS (7S) as shown in the upper diagram.
NOTE: Do not tighten the screws at this time.
å
Fasten a PULL (117K) to the DRAWER FRONT (H). Use
å
two BLACK 7/8" MACHINE SCREWS (37S) as shown
in the lower diagram. Completely tighten the PULL and
DRAWER FRONT MOLDING screws.
Repeat this step for the other DRAWERS.
å
Rounded edge
Page 16
I
H
117K
H
(20 used for the DRAWER MOLDINGS)
I
BLACK 7/8" MACHINE SCREW
(10 used for the PULLS)
418013
Almost time to
celebrate! With a nap.
7S
BLACK 1-1/4" FLAT HEAD SCREW
37S
www.sauder.com/services
Publicidad
