Publicidad
Step 13
Carefully stand your unit upright.
å
Position your unit in its fi nal location. We recommend
å
using the SAFETY STRAP (60M) for added stability.
NOTE: Do not turn the SAFETY DRYWALL
å
ANCHOR (61M) into a wall stud. If you prefer to fasten
the SAFETY STRAP (60M) to a wall stud, go to your
local hardware store for proper hardware.
INSTALLATION INSTRUCTIONS: (Also available at
www.yl-anchors.com)
1. Insert the SAFETY DRYWALL ANCHOR (61M)
å
through the WASHER (13M) and one end of the
SAFETY STRAP (60M).
2. Using a Phillips screwdriver or a hand drill, press
screw slightly onto the drywall.
3. Apply pressure; turn the screw until a pilot hole is
made and the nylon sheath slips through.
4. Turn the screw until it is fl ush against the wall and
you feel a fi rm resistance.
5. Continue to turn until the screw starts spinning freely.
Carefully cut out the perforated hole in the BACK (E).
å
Insert the other end of the SAFETY STRAP (60M)
through this hole, then use a BLACK 9/16" LARGE
HEAD SCREW (1S) through the SAFETY STRAP and
into the pre-drilled hole in the underside of the TOP.
NOTE: Before moving your unit to a diff erent location,
å
unscrew the SAFETY DRYWALL ANCHOR (61M)
from your wall. The nylon sheath will remain behind
your wall.
www.sauder.com/services
BLACK 9/16" LARGE HEAD SCREW
(1 used in this step)
418013
1S
13M
61M
60M
E
Page 17
Publicidad
