AquaTerra Ventura Manual Del Propietário página 14

JETS OPERATION
Jet Pump 1 button:
• Press Jets 1 button once to turn Jet Pump 1 on low speed.
• Press Jets 1 button a second time to turn Jet pump1 on high speed.
• Press Jets 1 button a third time to shut Jet Pump1 off.
Jet Pump 2 button: (Not available on all models)
• Press Jets 2 button once to turn Jet Pump 2 On.
• Press Jets 2 button a second time to shut Jet Pump 2 Off.
MULTI COLOR LED LIGHT
Press the Light button once to turn on the lights, press the button again to turn the lights off, when
turning back on after several seconds the same light mode will appear. Every time the light is
quickly turned off and on a new light mode will appear. The sequence is as follows:
White, Aqua, Magenta, Azure, Amber, Emerald, Ruby, Color wheel with abrupt
color changes, Slow full color wheel and Fast full color wheel.
NOTE: If left on, the light will automatically turn off after 4 hours of operation.
MODE
CLEANUP MODE (2 pump models only)
Press the Mode button to start the cleanup cycle for one minute. The display will
show CLn" message. This mode forces a purge step of the programmed filter
cycle and is useful when the user wishes to cleanup the spa water after use
without waiting for the next filter cycle purge. When active, the display will toggle
between CLn and water temperature.
SOAK MODE (2 pump models only)
Press and hold the Mode button for 5+ seconds until SbY is displayed. The soak mode clears
all pending user demands as well as filtration and smart winter mode. The only
automatic feature that remains functional is the water temperature regulation.
OFF MODE (all models)
Press and hold the Mode button for 8+ seconds until OFF is displayed. This function is useful to
preform simple spa maintenance. When enabled the display will toggle between OFF and water
temperature. This function will clear all pending user demands for 60 minutes. This mode will be
cancelled if the user starts a pump.
NOTE: If the spa is calling for heat it will take 1 minute before the jet pump will shut off.
FILTER CYCLES
There are two filter cycles: the first cycle (F1) starts right after power up and the second cycle (F2)
will start 12 hours later. The default duration for the first filter cycle is 1 hour, and 30 minutes for the
second cycle. The "Filter" indicator
cycle can be modified. If the "Filter" indicator
in the filter cycle.
CONTROL PANEL OPERATION
lights up when a filter cycle is on. The duration of each filter
flashes this indicates there has been a suspension
11