Publicidad
OPERATING INSTRUCTIONS
Adjust the Height
When you press "∧", the desk goes upward until it reaches the highest point.
When you press "∨", the desk goes downward until it reaches the lowest point.
When you press "∧" or "∨" brie y, the desk goes a small distance correspondingly.
Set Memory Heights
Set the height: 2 memory heights can be saved as follows.
1. Adjust the desktop to the desired height.
2. Press "1" or "2" for 4 seconds until "S-1" or "S-2" ashes.
Memory height inquiry: press "1" or "2" brie y and the corresponding memory height will ash.
Adjust the desk to the memory height: double-press "1" or "2" and the desktop will automatically
move to the corresponding memory height. Pressing any button will stop the process.
Set the Minimum Height
Set the minimum height: the minimum height of the desk can be set to avoid collision. If the
desktop reaches the minimum height, the display will show "- L o". The procedure is as follows.
1. Adjust the desk to the desired height.
2. Press "2" and "∨" for 5 seconds until the display shows "- d o".
Remove the saved minimum height:
Method 1: refer to the Initial Setup procedure.
Method 2: Adjust the desk to the minimum height. Press "∨" and "2" for 5 seconds until the
display shows "- d o".
Set the Maximum Height
Set the maximum height: the maximum height of the desk can be set to avoid collision. If the
desktop reaches the maximum height, the display will show "- H I". The procedure is as follows.
1. Adjust the desk to the desired height.
2. Press "∧" and "1" for 5 seconds until the display shows "– u p".
Remove the saved maximum height:
Method 1: refer to the Initial Setup procedure.
Method 2: a. Adjust the desk to the maximum height. b. Press "∧" and "1" for 5 seconds until the
display shows "– u p".
Initial Setup
(Perform this procedure in normal operation, or when the control box is replaced for the rst
time)
Press "∧" and "∨" at the same time until the display ashes "- - -". The system will enter the
initialization mode and the desk will automatically move up and down. Once the desk stops, the
initial setup process is complete.
Factory Reset
(Perform this procedure when the error code "E12", "E16" or "rST" occurs)
Press "∨" for 5 seconds until the display ashes "- - -" and the system will enter the reset mode.
The desk will automatically move to its lowest height regardless of the previously set height limits
and then rise to a pre- programmed height. Once the desk stops, the reset process is complete.
20
Publicidad
