Publicidad
Idiomas disponibles
Idiomas disponibles
1 - Plug the juicer into an appropriate outlet. Observe the values defined in the technical specifica-
tions section.
2 - Place a container underneath the juice spout (2)
3 - Cut the fruit in half. Open the lid and put one of the halves on the juicer cone (11). Gently push
the fruit down so it does not move. To avoid problems during the juicing cycle it is very
important that the piece of fruit is properly centred.
4 - Close the lid (6) and make sure it is locked with the lid closure (1).
(PHOTO 1)
5 - Push the ON/OFF button (3) to turn the juicer on. It will make a beep and the START button (4)
will light up.
6 - Push the START button until you hear a beep. The motor will start up and raise the insert and
make it spin to extract the juice from the fruit.
7 - The extracted juice is stored in the juice container (13). Push the juice spout downwards to
let the juice drain out into the container. Make sure to empty the juice container before the
juice reaches the maximum level mark. (PHOTO 2)
WARNING
: If there is a power outage during the cycle or the fruit has not been inserted
properly the juicer will stop automatically and make a beep and the RESET button (5) will
start blinking. Push the RESET button so the motor lowers into its original position. Make sure
the fruit has been inserted properly and start the cycle again.
8 - After squeezing the juice from half of the fruit, the motor will automatically end the cycle and
stop running.
WARNING:
Do not open the lid until the motor is completely stopped.
9 - After the motor has stopped, lift the lid closure and the lid to remove the fruit peel and flesh
from the filter (12).
10 - Repeat the process with all the pieces of fruit you want to make juice from.
11 - Push the ON/OFF button to turn off the juicer after you have finished squeezing the juice.
Unplug the juicer.
40
OPERATION
1
2
Publicidad
