Publicidad
Idiomas disponibles
Idiomas disponibles
6.
Once fitted in place, the bedguard should be checked to ensure it is properly
fitted and secure.
7.
The bedguard should be periodically checked for it's general condition with
particular reference to the security of any locking mechanism and/or hinges
that are used on the product.
8.
Additional and replacement parts should be obtained only from the
manufacturer.
9.
The bedguard should not be used on a sleeping surface that is more than
600 mm from the floor.
10. WARNING - To prevent the risk of strangulation it is essential to ensure
that when the bedguard is fitted into position, there is a gap of at least
250 mm (10in), between each end of the bed and the corresponding end
of the bedguard.
Appearance (fig. 1)
Part list
Bedguard (2x big tube, 2x small tube, material covering, 2x bedguard base , 4x
screw), 2x belts, instructions for use.
Assembly instruction (fig. 2)
a.
Small end
b.
Large end
1.
Tubes assembly and cloth placing (fig. 3)
a.
Press the lock button
b.
Connect the tubes
c.
Make sure the lock has been properly secured
d.
Put the material on the tubes at one side
min.
25 cm
‑ 7 ‑
min.
25 cm
EN
Publicidad
