Green light flashes 10 times
Note:There is enough liquid, but the orange light flashes ten times,
during orange light flashing please press power button key once to
continue work.
2. Prepare:Cleaning and disinfecting the components and spray
nozzle medication cup before using.
3. Inject the liquid: Open the liquid cup by lifting the clip, add liquid to
the liquid cup, then close the liquid cup.
Note
Please add the liquid before
turning on the device.
Note:Leakage protection! When pouring medication into the medication
container, ensure that you only fill it up to the maximum mark (8ml). The
recommended filling quantity is between 2 and 8ml. Nebulisation only
occurs while the substance to be nebulised is in contact with the mesh. If
this is not the case,nebulisation stops automatically.So please try to hold
the device as vertically as possible.
4.Nebulization
1) Connect mask or mouthpiece, press"
on, start nebulization.
2) lt starts with a medium spray rate,and the spray rate can be
adjusted by pressing "+"&"-" as needed;
3) This device has a Micro-wave mode in which the spray rate
is changed automatically from max to mini rate or converse in 6
seconds. After switching to the micro-wave mode, long press"
for 3s (when the green light flashes 3 times) to switch to the uniform
nebulization mode.
10 minutes set time
12
"power button to turn
" button