Publicidad
Idiomas disponibles
Idiomas disponibles
the tool falls, or replace with a
new accessory. After checking
and installing the accessory,
keep yourself and bystanders
far away from the rotating
accessory and run the tool for 1
minute under the maximum no-
load speed.
h)Wear protective equipment.
Based on the situation, use
mask, goggles or safety
glasses. Wear dust mask,
hearing protectors, gloves and
apron which can protect you
from some small segments or
chips when applicable.
i) Bystanders must keep a safe
distance from the working area.
Anyone who enters the working
areas must wear protective
equipments.
j) Keep the soft lines far away
from rotating parts.
k)Do not lay down the tool until
the accessory stops completely.
l) Do not switch on the tool when
carrying it.
m) Clean the air vents of the tool
often.
n) Do not operate the tool near
the inflammable materials.
o)Do not use the accessories
which need cooling liquid.
Further safety Instructions for
All Operation
a) Hold the tool firmly, and make
sure your body and arms in a
correct posture to resist bounce.
If auxiliary handle is provided,
always use it so as to maximum
control the bounce or counter
torque when the tool starts.
b) Never get close to rotating
parts.
c) Do not stand on the place
where the tool may move to
when bouncing.
d) Be very careful when working
on the sharp corners or edges.
Avoid you from accessories
bouncing or twining.
e) Do not attach the saw chain,
blade or sawblade with teeth.
SAVE THESE INSTRUCTIONS
WARNING! MISUSE or failure
to follow the safety rules stated
in this instruction manual may
cause serious personal injury.
DESCRIPTION OF SYMBOLS
The rating plate on your power
tool may show symbols. These
represent important information
about the product or instructions
on its use. Double insulated for
additional protection.
EN
7
Publicidad
