Publicidad
Idiomas disponibles
Idiomas disponibles
foreign matter from the pad. Then carefully align the
holes in the abrasive paper with those in the pad
and paste the abrasive paper firmly with your hand.
Caution: If you peel off the abrasive paper from
the pad, the adhesion will be decreased, therefore,
do not stick it to the pad for further use.
● Installing Dust Bag
1.Install the dust bag on the tool so that it inclines
upward. As shown in the figure.
● Sanding Operation
1.Hold the tool firmly. Turn the tool on and then slightly
apply it to the workpiece, as shown in the figure.
Generally, this tool only applies to micro grinding
for the surface of workpieces. The grinding quality
is more important than the grinding amount and
grinding rate. Thus, do not apply strong pressure
to grind. Keep the baseplate aligned over the
workpieces. Good finish can be obtained on the
furniture or fine surface if put a cloth under the
workpieces.
Cautions:
Never plug up the air outlet with your fingers or
hand.
Never run the tool without the abrasive paper. You
may seriously damage the pad.
This tool is not waterproof, and do not use water
on the workpiece.
Maintenance and Care
Caution: Always be sure that the tool is
switched off and unplugged before attempting
to perform inspection or maintenance.
●
Check the mounting screws
1：Dust Bag
1
Should always check whether mounting screw
fastening safely. If found loose screws, shall
be immediately to tighten, so as to avoid an
accident.
●
Maintenance of the Motor
The motor unit winding is the very "heart" of the
power tool. Exercise due care to ensure the
winding does not become damaged and /or wet
with oil or water.
After Use
●
Do not put down the tool immediately after the tool
is turned off. Wait until the tool completely stops
before putting it down. This can not only avoid
accidents, but also reduce a large amount of dust
and fine debris being sucked into the tool.
Clean the air vents
●
The air inlet and air outlet of the tool should be
cleaned regularly or at any time when it is blocked.
●
Check the Carbon Brushes
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark.
Keep the carbon brushes clean and free to slip
in the holders. Both carbon brushes should be
replaced at the same time.
●
Replace the Carbon Brushes
Use a screwdriver to remove the brush cover, take
out the worn carbon bush and replace a new one,
and then tighten the brush cover securely.
Replaceable Parts: Carbon Brush, Switch, and
Cord
If the replacement of the supply cord is necessary,
this has to be done by the manufacturer or his
agent in order to avoid a safety hazard.
1.Limit Mark
1
EN
9
Publicidad
