Publicidad
Idiomas disponibles
Idiomas disponibles
● The electric wires and electric equipment are not allowed to be placed on the top of
the gas water heater. The horizontal distance between the gas water heater and
other electric equipment should be more than 400mm.
● The power socket must have a reliable ground wire to improve safety. In order to
reduce the number of times of plugging, it is better to use a socket with a switch.
Whenever the water heater finishes working, please switch it off to avoid being
electrified in a long term. The power supply socket should not be installed in the moist
environment.
● The socket should be installed at the side of the product, and never be installed below
the machine or the place with splashes, near the heat source, in exposure to sun and
rain, or the place where it is not easy to control.
● The installation place of socket must be far away from the spraying space, so as to
avoid spraying the socket during shower.
◼ Installation Method
1. Installation of Gas Water Heater
Drill holes in the wall according to Fig.9, put an expansion bolt into the upper hole and
plastic gasket into the lower hole, mount the water heater vertically on the upper bolt
without inclination and tighten the lower holes with expansion bolts.
2. Installation of water and gas pipes (Fig. 10)
● It can be used when the flue system can ensure that the provided gas pressure can
reach the lowest requirement. If gas water heater reaches the rated heat input, the
gas pressure must reach the rated heat input in the technologic parameter form.
Fig. 9 (Unid.: mm)
42
Publicidad
