Publicidad
Idiomas disponibles
Idiomas disponibles
10. Make sure the power trigger is in the "off" position and remove the finger from the trigger before connecting
the tool to the power grid.
11. The tool model must be chosen in compliance with the established use. Do not force your equipment exces-
sively. If required, acquire a more suitable tool for the application. This will increase the efficiency and safety
in the work;
12. Never use your tool with your weight on it, forcing the equipment.
13. Do not make holes on power cords, gas or water pipes. Contact with water or electric wires may cause
electric shock. The electric motor of the tool generates sparks which in contact with flammable gases may cause
an explosion;
14. Fastening of the part: To avoid accidents, always fasten the part properly before starting drilling, especially
small parts. If required, use clamps.
15. Use your tool only for the purpose it was designed, according to the intended use described in this manual.
Do not use it for other purposes;
16. Do not expose your power tool to rain or wet conditions. Contact with water will increase the risk of electrical
shock;
17. Remove all adjustment tools before turning your equipment on. A tool or part stuck in moving of the equip-
ment may cause serious injuries;
Workplace and Point of Use:
- Keep the place clean, tidy and illuminated.
- In order to avoid distractions and accidents, after using your tool, isolate the workplace to prevent access of
visitors, children or animals.
- Power outlet must be compatible to the tool plug. To reduce the risk of shock, do not change the plug characte-
ristics and do not use adapters. If required, replace the outlet with a plug suitable model.
ATTENTION
mum section of 2.5 mm², up to 13 meter long). Use of inappropriate extension cords may increase the risks of
electric shock and damage the equipment.
Only use extension cords with impact resistance, insulation and suitable section (mini-
21
Publicidad
