Publicidad
Idiomas disponibles
Idiomas disponibles
Using your tool
1. Hold the grinder tightly with one hand on the side handle and the other on the body of the tool, as shown below;
6. PREVENTIVE MAINTENANCE
Maintenance and cleaning:
Before performing any cleaning or maintenance, unplug the tool from the power grid; After use, clean the tool
with a damp cloth (do not pour water on the tool) and store it in a clean, dry place protected from moisture and
dust. Keep your tool out of reach of children and people unfamiliar with the use of the equipment.
Transportation:
Do not pull or carry the tool by the electric cord or allow its contact with edges, sharp elements, rough surfaces,
oil or chemicals that may damage its flexible and insulating properties;
Do not move the tool with the trigger locked in the "on" position;
Repairs:
If required to perform any repair or replacement of the electric motor brushes, contact the nearest Schulz assis-
tance. Original parts Schulz must be used. The use of non-original parts results in warranty loss and may cause
damage to the equipment or injury.
2. The guard must be installed in such a way that the exposed part of the wheel
faces away from the user;
3. Be careful with the sparks when the wheel touches the metal or the material to
be grinded down;
4. When grinding, always keep a correct angle between the wheel and the surface
of the workpiece (30° to 40°). This procedure will increase the capacity of the grin-
ding wheel and avoid unnecessary overloads.
25
Publicidad
