Metra 95-7399B Instrucciones De Instalación página 3

1. Attach the radio brackets to the radio
trim panel using (4) #8 x 1/4" Phillips
screws supplied. (Figure A)
2. Slide the radio into the completed
assembly, and then secure it to the
assembly using screws supplied with
the radio. (Figure B)
3. Attach the blank panel clip legs to the
blank panel using (2) #6 X 3/8" Phillips
screws supplied. (Figure C)
4. Attach the panel clips to the panel legs.
(Figure D)
KIT ASSEMBLY
(Figure A)
(Figure B)
5. Snap the blank panel into the factory
trim panel. (Figure E)
6. Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS. Re-connect the negative
battery terminal and test the radio for
proper operation.
7. Reassemble the dash in reverse order of
disassembly.
(Figure C)
(Figure D)
(Figure E)
REV. 4/15/2022 INST95-7399B
3