Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
outdoor unit does not start.
Display
See picture 05 on page 5.
The icons that appear on the digital display
and their meaning are shown below:
23.
Timer (ON)
24.
High fan speed
25.
Low fan speed
26.
Sleep mode
27.
Cooling mode
28.
Fan mode
29.
Wi-Fi control
30.
Dehumidification mode
INSTALLATION
Installation location of the air conditioner
The air conditioner must be placed on a firm,
flat surface (note: the air conditioner must
not be tilted or tilted) when the appliance
is in use. This mobile air conditioner may
not be installed in the following places:
• Near strong heat sources, vapors and
flammable or explosive gas.
• In
an
environment
chemicals
(evaporating
organic solvents, etc.), as soon as it
rains, the air conditioning must be
removed from the window.
• For outdoor use, the air conditioner
must be kept away from rain and / or
water.
Also take the following regulations into
account:
• The product must be kept upright at all
times and in all cases. Do not hold the
device sideways or upside down.
• Try to keep the air conditioner straight
when moving or carrying it. Make sure
it is not shaken or dropped.
• Make sure the air supply is not clogged
and remains well ventilated.
• Do no insert objects through the
openings of the air inlet and outlet.
22
Installation of the air conditioner
that
contains
substances,
See picture 04 on page 5.
See picture 13 on page 6.
See picture 06 on page 5.
Objects can encounter electrical parts
or the fan in this way and could be
dangerous.
• Do not place heavy objects on the
product.
• Remove the plug from the socket before
moving the air conditioner, performing
maintenance, cleaning or not using it
for a long time.
• Do not pull the plug to move the
machine.
• Clean the dust screen of the air supply
at least once a month.
• If the machine will not be used for a
long time, it must be stored in a cool
and dry place. Clean and dry the air
conditioner well in advance.
• Unpack the machine and accessories
and check that the hose between the
indoor and outdoor unit is properly
connected. Also check whether the
condensation drain has a rubber cover.
Finally, check whether the accessories
are complete.
• Install the accessories as shown in the
picture. Connect the outer bracket to
the support block and the inner bracket
by tightening the hand screws. This is
how you form the carrying handle.
• Place the shock resistant rubbers on
the back of the outdoor unit.
31. Shockproof rubber dampers
32.
Shockproof rubber dampers
• Install the bracket as shown in the
figure below. Install the indoor and
outdoor units on the bracket to fix the
two parts. To secure the units to the
bracket, tighten the hand screws in the
appropriate holes.
• Install the indoor unit on the bracket
Publicidad
