Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Note
When you set the switch to ON\ HOT or COLD, the cutting unit will be unlocked and
the laminating pouch will be free accessible. Slide the switch to OFF (Trimmer) and
you can lock the cutting unit again to use the trimmer.
Clearing a blockage of the film
1.
This machine is equipped with a film blockage function in order to resolve
any blockage of the film (ABS).
2.
At the start of the lamination process, the pouch may be pulled in at an
angel or jam itself inside the appliance.
3.
Slide the Anti-Blocking switch ABS to the left. The laminating pouch is not
pulled any further in.
4.
Remove the laminating pouch completely from the machine's feed
opening or delivery opening.
5.
After you have resolved the blockage of the film release the ABS switch.
Re-start the lamination process.
6.
Please contact our service-hotline if there is a blockage of the film again.
Cleaning and care
1.
Please pull out the plug from the mains socket outlet always, in order to
clean the machine. Take care while doing so that the plug does not come
into contact with any liquids.
2.
Allow the machine to cool down before cleaning it.
3.
Clean the machine with a slightly moist, soft cloth. Do not use any caustic
or abrasive cleaning agents while doing so.
Technical data
Mains voltage (V)
Consumption
Laminating width
Size of the machine (mm)
Film
of
utilizable
(microns)
Heating up time
Speed
220 V to 240 V, 50 Hz
1.4 A
230 mm
416 x 212 x 96
thickness
80
minimum,
maximum
≤ 3 min.
250 mm / min
125
12
Publicidad
Tabla de contenido
