tuc tuc i-size Instrucciones De Uso página 63

Then, pull the seat towards you to ensure it is correctly locked in place.
Note: The ISOFIX attachment comprises two metal studs per seat, located in
the gap between backrest and seat cushion. In case of doubt, check with the
instruction manual for your vehicle.
If it is difficult to access the ISOFIX system, use connecting guiderails (included
with the car seat) to help with the installation and avoid damaging the
upholstery.
Note: Do not place anything in the footwell in front of the child restraint system.
2.- ADJUSTING THE POSITION OF THE SUPPORT STAND
2a. Push the button on the support stand (3) and pull until the leg locks into
position to ensure optimal placement.
2b. Ensure the indicator on the stand is green (7) .
WARNING! The support stand must always be resting on the floor. Do not place
any objects under the support stand. For more information on compartments
located in the footwell of some cars, see the instruction manual for your car.
Note: Ensure the i-Size restraint system is flat on the seat.
3.- REMOVING THE RESTRAINT SYSTEM FROM THE VEHICLE
Follow the installation process in reverse.
3a. Undo the ISOFIX connectors (5) on either side of the child restraint system.
Hit the connecting buttons (6) at the same time.
3b. Push the ISOFIX extender button (4) and set it to its shortest length.
3c. Press the buttons (3) on the lower section of the support stand and place it
horizontally underneath the seat, i.e. in its original position. Fold the front leg
under the base.
63