Publicidad
Technical Data
Code
Description
Chuck
Voltage
Current
Power
Drilling Capacity
Speed
Impact
Duty Cycle
Conductors
Insulating
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
WARNING
Power Requirements
WARNING
Tools with double insulation and reinforced insulation eliminate
the need of a grounded power cord with three prongs or a grounded power
connection.
WARNING
When using an extension cable, verify the gauge is enough for
the power that your product needs. A lower gauge cable will cause voltage drop in
the line, resulting in power loss and overheating. The following table shows the
right size to use depending on cable's length and the ampere capability shown in
the tool's nameplate. When in doubt use the next higher gauge.
Ampere
Capacity
From 0 and up to 10 A
From 10 and up to 13 A
From 13 and up to 15 A
From 15 and up to 20 A
* It is safe to use only if the extensions have a built-in artifact for over current protection.
220 V
Metal: 0.51" | Concrete: 0.51" | Wood: 0.98"
1: 0 - 1 200 RPM
1: 0 - 20 400 strokes/min
50 minutes' work per 20 minutes idle. Maximum 6 hours per day
H05VV-P 2X1.0 mm
Class II
Power Cord Grips used in this product: Type "Y".
Thermal insulation on motor winding: Class B
Number of
Conductors
3 (one grounded)
AWG = American Wire Gauge - Reference NMX-J-195-ANCE
ROTO-1/2N7-2
15202
Hammer Drill
1/2"
Frequency
4 A
1.2 Hp
2: 0 - 3 300 RPM
2: 0 - 56 100 strokes/min
with insulating temperature of 221 °F
2
IP Grade
Tool Build Quality: Reinforced
Authorized Service Center.
Extension Gauge
From 6 ft to 49 ft
|
18 AWG
16 AWG
14 AWG
8 AWG
50 Hz / 60 Hz
IP20
Higher than 49 ft
16 AWG
14 AWG
12 AWG
6 AWG
ENGLISH
3
Publicidad
