SNOWJOE sunjoe 24V-PRN1-LTE Manual Del Operador página 12

• Failure to insert batteries in the correct polarity, as
indicated in the battery compartment or manual, may
shorten the life of the batteries or cause batteries to leak.
• Do not mix old and new batteries.
• Do not mix Alkaline, Standard (Carbon-Zinc) or
Rechargeable (Nickel Cadmium, Nickel Metal Hydride, or
Lithium-Ion) batteries.
• Do not dispose of batteries in fire.
• Batteries should be recycled or disposed of as per state
and local guidelines.
Service + Support
If your Sun Joe ® 24V-PRN1-LTE Cordless Handheld Pruner
requires service or maintenance, please call the Snow Joe
Sun Joe ® customer service center at 1-866-SNOWJOE
(1-866-766-9563).
Model + Serial Numbers
When contacting the company or reordering parts, you will
need to provide the model and serial numbers of your product.
These are found on the decal affixed to the housing or handle
of your cordless pruner. Copy these numbers into the space
provided below.
Record the following numbers from the housing or handle of your
new product:
Model #:
2 4 V - P R N 1 - L T E
Serial #:
XZ2600-0450
Federal Communications Commission
(FCC)
m
WARNING!
unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the
equipment.
This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
® +
Class B device:
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur
in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment to an outlet on a circuit different
than the one the receiver is currently connected to.
• Consult the dealer or an experienced radio/TV technician
for help.
12
Any changes or modifications to this