Mitsubishi Electric Mr.SLIM PEAD-A09AA8 Manual De Instrucciones página 8

4. Timer
Timer functions are different by each remote controller.
Refer to the operation manual that comes with each remote controller for the details included an operation method.
5. Emergency Operation for IR Wireless Remote Controller
ON/OFF
HEAT
6. Care and Cleaning
► C leaning the filters
• Clean the filters using a vacuum cleaner. If you do not have a vacuum
cleaner, tap the filters against a solid object to knock off dirt and dust.
• If the filters are especially dirty, wash them in lukewarm water. Take care
to rinse off any detergent thoroughly and allow the filters to dry completely
before putting them back into the unit.
Caution:
• Do not dry the filters in direct sunlight or by using a heat source, such
as an electric heater: this may warp them.
• Do not wash the filters in hot water (above 122 °F [50 °C]), as this may
warp them.
• Make sure that the air filters are always installed. Operating the unit
without air filters can cause malfunction.
Caution:
• Before you start cleaning, stop operation and turn OFF the power sup-
ply.
• Indoor units are equipped with filters to remove the dust of sucked-in
air. Clean the filters using the methods shown in the following sketches.
8
1
2
COOL
1 ON/OFF lamp (lit when unit is operating; unlit when unit is not operating)
2 Emergency operation
In cases where the remote control unit does not operate properly, use
either the COOL or HEAT button on the wireless remote control
signal receiver to toggle the unit on or off. On cooler only units, pushing
HEAT button toggles the fan on and off.
the
Pressing the COOL or
Operation mode
Preset temperature 24 °C/75 °F
Fan speed
►Filter removal
Caution:
• In removing the filter, precautions must be taken to protect your eyes
from dust. Also, if you have to climb up on a stool to do the job, be
careful not to fall.
• When the filter is removed, do not touch the metallic parts inside the
indoor unit, otherwise injury may result.
PEAD-A·AA8
B
D
• While lifting the filter knob, pull it.
A Air intake B Air outlet
HEAT button selects the following settings.
COOL HEAT
24 °C/75 °F
High High
A
C
D
C Filter D Knob