Emerio COM-129107.1 Manual De Instrucciones página 8

COM-129107.1 / COM-129107.2
STRUCTURE ILLUSTRATION
A: Refrigerator compartment
1. Light and thermostat
2. Glass shelves
3. Crisper cover
4. Crisper
5. Door racks
6. Ice box
7. Egg tray
B: Freezer compartment
8. Drawer
INSTALLATION
To fix stably, the appliance must be placed on a flat and solid surface. It should not be placed on any soft material.
Choose a location where there is no heat source. Keep the refrigerator away from direct sunlight or other
appliance producing heat.
Choose a dry and well-ventilated place where there is no corrosive air.
In order to improve efficiency of the cooling system and save energy, it is necessary to maintain good ventilation
around the appliance for the dissipation of heat. Therefore, at least 30mm of free space should be spared at the
top side, more than 100mm on both sides, and above 50mm at the back side of the refrigerator.
(Dimensions in mm)
W D H
470 495 1440
Pull out the bottom panel before installation.
The appliance can be adjusted by turning its two front feet when it is unstable. Turning in clockwise can rise up
the machine.
Make sure the adjustable feet are clung to the floor, and set the appliance slope backward slightly for keeping
the doors closed tightly.
FIRST USE
Before use of the refrigerator, remove all the packaging, including the bottom cushion, foam pads and rubber
belts in the refrigerator.
Adjust the feet and clean the outside and inside of the refrigerator with warm cloth.
Do not start the refrigerator immediately after vertical placement. Only start it after about 4 hours of standing
to ensure its proper operation.
A B C(°)
792 923 130±5
E F
50 100
- 7 -
EN