Publicidad
Idiomas disponibles
Idiomas disponibles
Water full alarm
Under normal use, the unit can evaporate the condensed water automatically, and little of water will be
accumulated in the inner water tray.
As soon as the condensed water collected in the inner water tray reaches a certain height, a water full alarm
will be sent out: the water full indicator light will illuminate, and the digital display will show "E2" code approx.
5 minutes later.
Thus, when the water full alarm occurs, please drain the water in the water tray. Remove the rubber stopper
from the drain port at the bottom of the unit, and drain out the water.
Continuous drainage
Continuous drainage can be used to avoid the water full alarm disturbance. Prepare a drain hose. Connect it to
the drain port to drain out the water. The unit can also work well.
-
If you plan to leave this unit unused for a long time, please use the drain port to drain out the water.
-
If the condensed water accumulates fast and leads to water full alarms shortly, the splash motor inside the
machine may be damaged. In this case, please contact our service department at www.emerio.eu/service
Wi-Fi CONNECTION GUIDE (This guide for the APP may not be up to date due to software version upgrade or
other reasons. This instruction is used as a guide only. Below mobile phone interface uses English version in
iOS as an example.):
1. Search "Tuya Smart" in App Store (for iOS) or Google play (for Android) to download the application.
2. Sign up or log in to your account on the APP. Tap the "+" at top right corner or button "Add Device" to add
your device. (Fig.1)
3. Find "Large Home Appliances" and tap the icon "Air Conditioner (Wi-Fi)". (Fig.2)
You will get the prompt that asks you to use 2.4 GHz Wi-Fi network and enter password. (Fig.3) Tap "Next"
to get Fig.4.
Note: When setting up Wi-Fi function you need to select an available 2.4 GHz network and connect the
appliance. Your mobile needs to be connected to the same network in order to set up Tuya Smart in the
phone. When this is done you can access the appliance from your phone on any network.
There are two ways to do the net pairing. Press and hold the wind speed button on the control panel for
approx. 5 seconds until a beep sound is heard, the Wi-Fi indicator light will blink quickly (way 1). Continue
to press and hold the wind speed button for another 5 seconds until a beep sound is heard, the Wi-Fi
indicator light will blink slowly (way 2).
It is recommended to use way 1; if failed please use way 2.
Way 1:
1) Press and hold the wind speed button for approx. 5 seconds until a beep sound is heard and the Wi-Fi
indicator light blinks quickly.
2) Tap "Confirm the indicator is blinking" in Fig.4. You will get Fig.5 that asks you to select the status of
the indicator light. Tap "Blink Quickly".
3) Wait until you get Fig.7 and then tap "Done".
4) Now you can operate your device in the control interface. Tap buttons to set your appliance.
Way 2:
1) Press and hold the wind speed button for approx. 5 seconds until a beep sound is heard and the Wi-Fi
indicator light blinks quickly. Continue to press and hold the wind speed button for another 5 seconds
until a beep sound is heard and the Wi-Fi indicator light blinks slowly.
- 9 -
Publicidad
