Usage Instructions; Maintenance And Storage - Hudora Hollywood Instrucciones De Montaje Y De Uso

INSTRUCTIONS ON ASSEMBLY
Prior to installation, carefully select and check the location where you will in-
stall the swing. Please make sure that the swing carrier is adequately stable.
Please also take into account that swinging produces centrifugal forces that
can put a lot of strain on the swing carrier. Please consult an expert (statics
expert, architect, carpenter) and ask how much load your swing carrier can to-
lerate.Suspension connectors shall be of a design that will prevent unintentional
disconnection. After removing the product from its packaging, please check it
for completeness. Follow the assembly figures on pages 3-7 during the set-up
phase.

USAGE INSTRUCTIONS

HANGING DEVICE AND ADJUSTMENT
The clearance between the points from which you plan to hang the swing must
be at least as wide as the width of the seat of swing + 100 mm. The clearance
between the swing seat and the ground can be adjusted variably to fit any suita-
ble installation location since the swing includes 2 length adjustable straps (9).
Both straps are divided into two individual belts with one each terminal K and
one hand loop H. The length of each individual belt 9a and 9b can be adjusted
infinitely. To raise the swing (i.e. shorten the belt), keep terminal K pressed down
while you pull hand loop H down (Fig. 8b). To lower the swing (lengthen the belt),
keep terminal K pressed down while you keep hand loop H evenly controlled
and allow it to slide to the top (Fig. 8c). While you extend and shorten the belts,
always make sure that the two on the front and the two in the rear are of the
same length after the adjustment. Unequal belt lengths will result in uncontrol-
led pendular swing movements, which may cause injuries! While adjusting the
swing, make certain nobody is sitting on the swing. Adjust the swing in such a
manner that the person swinging cannot touch the ground with the tips of her/
his toes. If you are not certain that the fit is perfect, perform a few light-handed
test swings.
ADJUSTING THE SEAT
While you are adjusting the seat, make absolutely certain nobody is sitting on
the swing. To adjust the seat angle, press the button on the side of both joints
(5) simultaneously (Fig. 8d). While keeping both buttons pressed down, careful-
ly pull up the joint or carefully press it in the direction of the ground until the seat
is in the desired position. The movement of the joint also adjusts the location of
the seat. When done, please make sure that the buttons pop out of the joint
again and that the joint has locked firmly into its position. To protect the seat
cover (7) and the neck cushion (8), you will have to remove them after every use
of the swing. To do this, loosen all hook and loop fasteners from the swing frame
and store the padding as described in section Maintenance and Storage.
USE WITH HUDORA SWING SET STANDS
If you are using the swing in conjunction with the HUDORA Playground item no.
64019), you will have to remove both individual swings and nest swing Holly-
wood must be hung from the two exterior hooks. Nest swing Hollywood may
also be installed with the nest swing set 120 (item no. 64023).

MAINTENANCE AND STORAGE

Use a dry or damp cloth only to clean the product; do not use special cleaning
agents! Check the product for damage or traces of wear and tear before and
after each use. Do not make any structural changes. For your own safety, please
use original spare parts only. These can be sourced from HUDORA. If parts be-
come damaged or if sharp edges or corners should develop, the product may not
be used any more. If in any doubt, please contact our service team (http://www.
hudora.de/service/). Store the product in a safe place where it is protected from
the elements, cannot be damaged, and cannot injure anyone.
You should also replace all the plastic parts after a maximum of 5 years to pre-
vent a possible failure of these parts. The seat padding (7) and neck pillow (8)
should be removed after every use and should be stored in a dark place. Please
observe the following washing and cleaning directions for the seat padding and
neck pillow:
Hand wash only! Do not iron! Do not tumble dry! Do not bleach! Do not dry clean!
Check the product for damage or traces of wear and tear before and after each
use.
We also recommend before each use:
• to check for the firm sitting of nuts and bolts, tighten if necessary
• to lubricate moving parts in order to minimize wear.
• to check all covers of screws and sharp edges and replace if necessary
• to replace defective parts according to the manufacturer's instructions
• to check swing seats, chains, ropes and other means of attachments for evi-
dence of deterioration
DISPOSAL ADVICE
At the end of the product's life, please dispose of it at an appropriate collection
point in your area. Local waste management companies will be able to answer
your questions on this.
SERVICE
We make every effort to deliver faultless products. If faults do arise however, we
put just as much effort into rectifying them. You can find numerous information
on the product, replacement parts, solutions to problems and lost assembly
manuals at http://www.hudora.de/service/.
All images are examples of the design.
10/16