Derby Pendel DX 210x210 Instrucciones De Montaje página 11

Setting up the shade
In the box, you will find:
You will also need:
e.g. four fillable weight
plates of 35 kg each,
Order no.: 85499BP35
A protective sleeve for the sunshade may
be purchased separately in a specialist
shop if needed.
1. Pull the swivel plate incl. pole base 1
out of the shade pole 5.
2. Assemble the T-stand (see Figure A).
3. Set the T-stand up in the desired loca-
tion and place the four fillable weight
plates in position (see Figure B).
4. Use four screws 2 to mount the swivel
plate incl. pole base 1 to the T-stand
(see Figure C and D).
5. Insert the adapter 3 onto the swivel
plate incl. pole base 1 and secure it in
place with a screw 4 (see Figure E).
6. Slip the shade pole 5 over the adapt-
er 3 and secure it in place with two
screws 6 (see Figure E).
7. Fit the crank 7 to the attachment point
and secure it in place with the pre-in-
stalled screw (see Figure F).
The sunshade is now ready for use.
Opening the shade
Please note!
– Before opening the sunshade, ensure
that it has a sufficiently secure posi-
tion, that is, that the proper base is
used.
1. Undo the strap and remove the pro-
tective sleeve if necessary.
2. Open the sunshade slightly by hand.
In the process, turn the crank 7 and
open the sunshade completely (see
Figure G and H).
Tilting the shade
• To adjust the tilt of the sunshade, push
the locking button 8 on the handle and
slide the handle up or down. Let the
handle lock into place in the desired
position (see Figure I).
Rotating the shade
• To rotate the sunshade, push the lock-
ing lever 9 down with your foot. Then
turn the sunshade to the desired po-
sition (see Figure J).
Pivoting the shade
1. Push the lever 10 down (see Figure
K).
2. Pivot the sunshade to the desired po-
sition by hand (see Figure L).
3. Push the lever 10 back up and release
it (see Figure M).
When you let go of the canopy, the le-
ver will automatically lock into place.
GB
11