Derby Pendel DX 210x210 Instrucciones De Montaje página 12

GB
Closing the shade
Please note!
– The sunshade must be closed in the
event of incoming wind, rain or snow.
Damages occurring as the result of
failure to do so are excluded from the
warranty.
– When closing the sunshade, the cover
could get caught between the braces.
If this happens, please carefully pull
parts of the cover caught between the
braces out.
1. If necessary, pivot the sunshade back
into a level position (see Figure N).
2. Press the locking button 8 on the han-
dle and slide the handle down (see
Figure O).
3. Close the sunshade using the crank 7
(compare Figure G).
4. If the cover is caught between the
braces, carefully pull the cover be-
tween the braces out (see Figure P).
5. Tie the sunshade up with the attached
strap and then cover it with the pro-
tective sleeve if needed (see Figure P
and Q).
Changing the cover
Depending on the level of wear and tear,
it can be helpful to replace the cover.
New covers can be ordered from your
retailer.
1. Unscrew the shade tip 11 (see Fig-
ure R).
2. Remove the protective cap 12 from
the lock screw 13 (see Figure S).
3. Loosen the lock screw 13 with a size
4 hex key (see Figure S).
4. Pull the top layer of the cover 14 off
(hook-and-loop fastener). Pull the bot-
tom layer off as well.
5. Slide the cover off the braces (see
Figure T).
6. Pull a new cover over by reversing the
steps.
12
Care + storage
Cleaning the cover
Please note!
– The cover is not suitable for machine
washing!
– Do not use a tumble-dryer.
– Do not iron.
– Do not use aggressive chemical clean-
ing agents or fluids, solvents, abra-
sive substances or objects, bleach-
ing agents, high-pressure cleaners or
strong cleaning products.
– Comply with the manufacturer's dos-
ing, application and reaction instruc-
tions.
• Hand wash the cover at 40 °C.
To clean the cover, it is best to use
a soft brush and a small amount of a
soapy solution.
Maintaining the shade pole
• Clean the shade pole regularly to en-
sure that the mobile parts slide prop-
erly. If necessary, spray it with a sili-
con or Teflon lubricant spray.
• Check all load-bearing parts such as
braces, screws etc. regularly.
• Check the shade pole regularly for
rust spots and touch them up if neces-
sary. Use only a small amount of soap
solution for cleaning.
Storing the shade
• For over winter storage, take down
the sunshade in a completely dry
state and store it in a dry, well venti-
lated room.
• If possible, store the sunshade up-
right and without any load on the sun-
shade.
• At the start of the season ensure that
all components and fixings are se-
cure. If you are unsure, do not use the
product.