Bissell CROSSWAVE CORDLESS MAX DELUXE 2593 Serie Manual página 7

Filling the Clean Water Tank
Use the BISSELL Connect App to watch additional how-to videos.
The clean water tank is
1.
located on the back of the
machine. To remove, use the
finger groove at the top of the
tank to grab and pivot the tank
backwards.
The clean water tank has a large area volume and a small area
4.
volume. Pick one of the measuring volumes that best suits the
space that you would like to clean.
The Large Area fill lines are for areas up to 700 sq ft.
The Small Area fill lines are for areas under 350 sq ft.
Use warm (140°F/60°C max) tap water and add the appropriate
BISSELL formula. Tap water with hardness greater than 35 ppm
is recommended for use in machine to ensure the dirty water
tank full detection sensor works properly.
Unscrew the cap from the
2.
bottom of the clean water tank.
Small
Area
Choose the right BISSELL®
3.
formula from the 'Choosing
Your Brush Roll & Formula'
section on page 6.
Large
Area
Screw the cap back on
5.
the clean water tank. On the
back of the machine, align the
bottom of the clean water tank
with the grooves and pivot the
tank until it "clicks" into place.
BISSELL.com 7