Bissell CROSSWAVE CORDLESS MAX DELUXE 2593 Serie Manual página 8

Cleaning Your Floors
Go to support.BISSELL.com for how-to videos and tips for cleaning stuck-on messes,
excessively dirty or muddy floors, and more!
Mode
Power
Press the power button
1.
ON. Press the mode button to
switch between Hard Floor and
Area Rug Modes.
Area Rug Mode dispenses
double the solution as Hard
Floor Mode. Before cleaning
rugs, check the manufacturer's
tag and test an inconspicuous
spot for colorfastness. Don't
use on silk or delicate rugs.
To clean, hold the solution
4.
spray trigger to apply solution
on forward and backward
passes.
Sanitizing Hard Floors
Please read "DIRECTIONS FOR USE" on Hard Floor Sanitize label. Use on hard nonporous floors only.
Remove visible soil before
1.
cleaning. Hold trigger down to
apply solution on to the floor.
ATTENTION
rugs. Stalling the brush may result in premature belt failure.
8 BISSELL.com
Recline the machine to start
2.
the brush roll spinning. Stand
the machine upright to stop
the brush roll spinning.
To dry floors faster, release
5.
the trigger and make a second
pass without dispensing
solution.
Allow formula to remain wet
2.
on the floor for five minutes.
Do not overwet carpet or hardwood floors. Be careful not to run over loose objects or edges of area
5m
10s
Before each use, hold the
3.
solution spray trigger for 10
seconds to prime the system
with cleaning solution.
LED lights illuminate when
holding the trigger. Bubbles
will appear in the brush roll
window when the solution is
flowing.
Turn OFF the machine by
6.
pressing the power button ( ).
With the spray trigger
3.
released, make forward and
backward passes to extract
solution.