Publicidad
Idiomas disponibles
Idiomas disponibles
USERS MANUAL HEATER EHW200RC
3. Place the heater on a firm level surface, setting the master button to
"-"position. Plug the cord set into a AC220-240V~ electrical
outlet,with "BEE" sounds the "Power" light is on and the heater will
shows the default temperature, it will twinkle 3 seconds.
1) HEATING PERPARE
Set time
Before turn on the heater, set the time as right time. Press remote
control "
" button, light on control panel, LED display shows 00:00
and "Mo"light on.
HOUR Press "Set" button one time, LED display front "00" twinkle,
press"
two buttons set the Hours from 01--00(01=1 o'clock,02=2
o'clock...00=24 o'clock etc.)
MINUTE Press "Set" button again, LED display behind "00" twinkle, press
"
two buttons set the minutes from 00--59(01=1 Minute,02=2
Minute etc.)
WEEK Press "Set" button again, "Mo" light twinkle, press "
buttons set the week from Mo--Su (Mo=Monday...Su=Sunday etc.)
PS: Press "Set" button, screen shows number will twinkle 5 seconds, you
should operate in time ,otherwise appliance will get back to standby.
(Appliance will keep the right time until power off)
2) GENERAL USING OPERATION
1. Turn the heater ON by pressing remote control the ON/OFF button, the
unit will blow the cold air and "
2. Pressing the "MODE" button on remote control, the unit will blow the
warm air and both "
"and "
" lights are on.
3. Pressing the "MODE" button second times on remote control, the unit
will blow the hot air and both "
4. Pressing the "MODE" button three times on remote control, the unit
will blow the cold air and "Fan/M" light is on.
19
" light is on.
""
" lights are on.
PS: For smart operate, user only press the one start button near about
master button, the heater will working with hot air and both "
lights are on.
3) 24H TIMER FUNCTION
1.Open the appliance as working conditions,(fan, warm, hot are all
ok).This function through by Remote control "
2. Press "
" button, set the timer up to 24 hours, keep press "
button to increase the hours from 00--24(00=close,01=1hour,02=2
hours...24=24 hours etc.) and the "
PS: set as "00" means no set timer ,the "
4) THERMOSTAT INSTRUCTIONS
two
1. Open the appliance as working conditions,(fan, warm, hot are all ok).
This function only through by Remote control.
2. To adjust temperature, press the "
temperature and the temperature set from 10℃ to 49℃ with the control
panel "
" light on.
3. When the air temperature drops 2 degree below the set
temperature, the heater will start heating with "I/W"(1000W).
4. When the air temperature drops 4 degree below the set
temperature, the heater will start heating with "II/H"(2000W).
5. When the air temperature high 1 degree or ≥ the set temperature, the
heater will blow the cold air.
V.1
V.1
USERS MANUAL HEATER EHW200RC
" button .
" light is on.
" light is off.
" to set the desired
""
"
"
20
Publicidad
