2.2.
Safety in the work area
a) Keep the work area tidy and well lit. Disorder or poor lighting can lead to
accidents. Be careful, watch what you are doing and use common sense when
working with the device.
b) Do not use the device in an area with a risk of explosion, for example in the
presence of flammable liquids, gases or dust.
c)
In the event of damage or malfunction of the device, it must be switched off
immediately and the incident must be reported to an authorised person.
d) If in doubt as to whether the device is working properly, contact the
manufacturer's service.
e) Repairs to the device may only be carried out by the manufacturer's service. Do
not carry out repairs yourself!
f)
In the event of fire or fire, use only powder or snow (CO2) extinguishers to
extinguish fire in the device where there is voltage.
g) No children or unauthorised persons are allowed in the work area.
h) Use the device in a well-ventilated room.
i)
Keep these instructions for future reference. If the device is to be passed on to
third parties, the instructions for use must be handed over together with the
device.
j)
Keep packaging parts and small assembly parts out of the reach of children.
k) Keep the device away from children and animals
l)
When using this device together with other devices, the other instructions for
use must also be followed.
Remember! Keep children and other bystanders safe while operating the
device.
2.3.
Personal safety
a)
Do not operate the device if you are tired, ill or under the influence of alcohol,
drugs or medication which might impair your ability to operate the device.
b)
The device is not intended to be used by persons (including children) with
reduced mental, sensory or intellectual functions or lack of experience and/or
knowledge, unless they are supervised by a person responsible for their safety
or have been given instructions by them on how to operate the device.
c)
Be careful and use common sense when operating the device. A short moment
of distraction during operation may lead to serious personal injury.
d)
To prevent accidental start-up, make sure the switch is in the OFF position
before connecting the device to the power source.