Publicidad
Idiomas disponibles
Idiomas disponibles
way that the power supply plug can be reached at any time. Make sure that the
device's power supply corresponds to the data on the rating plate!
Before first use, disassemble all parts and wash them as well as the whole device.
3.3.
Working with the device
To mix/emulsify food products:
a)
Prepare the ingredients and put them into the container. The contents of the
container must not exceed the marked scale (100 to 750 mL). Do not overfill
the container.
b)
Make sure that the device control switch is in the OFF position (O), then plug
in the device.
c)
Hang the filled container on the hooks located on the column. A correctly
attached container should activate the safety button to prevent unintentional
switching on. If the container is removed from the hooks while the device is
running, the device will switch off. CAUTION! Do not put hands, fingers,
spoons or other objects into the container while the device is operating.
d)
Select and activate one of the available mixing speeds (I or II).
CAUTION: The device should not operate continuously for more than 3
minutes. After this time, stop operation and wait (at least 1 minute) until the
device has cooled down.
e)
Switch off the device by setting the control switch to the OFF position (O).
f)
Remove the container and its contents from the hooks.
g)
Unplug and wash the device.
3.4.
Cleaning and maintenance
a)
Before cleaning, adjustment or replacement of accessories, and when the
device is not in use, pull the power supply plug and let the device cool down
completely. Wait until the spinning elements stop.
b)
Clean the devices after each use.
c)
Use only non-corrosive agents for cleaning the surface.
d)
Only mild cleaning agents designed for cleaning surfaces which come into
contact with food may be used to clean the device.
e)
After each cleaning, all components should be well dried before the device s
used again.
f)
Store the device in a dry and cool place protected from moisture and direct
sunlight.
g)
Do not spray the device with a stream of water and do not immerse it in water.
h)
Ensure that no water enters through the ventilation openings in the housing.
i)
Clean the ventilation openings with a brush and compressed air.
j)
Regularly inspect the device for technical failure and damage.
Publicidad
