Publicidad
Idiomas disponibles
Idiomas disponibles
6. Serial number and rating plate
The machine number can be found on the front of the support arm and
glued to the frame. (see figure 9)
Figure 9: Positions of serial number and rating plate
7. Technical data
Product number
130.5010
Voltage:
220/230V, 50/60 Hz
Rotary speed:
45 U/min.
Protection class:
IP 54
Dimensions:
H 1150 x W 400 x D 1085 mm
Weight:
app. 129 kg
8. Troubleshooting
CAUTION:
During maintenance and repair works, the cow
brush must be disconnected from the mains.
Works on the electrical connection and repairs
may only be made by a qualified electrician.
Manipulation or modification of the equip-
ment/controller results in loss of warranty.
The machine does not switch on
The power supply to the machine is interrupted
• Please check that the machine is properly connected to the mains
supply. (Is it plugged into a 220V / 230V socket?)
• Is the machine switched on? The green control lamp on the
switch must light up.
• Check that power is being supplied to the socket.
• Is the cable damaged?
The machine is mounted too high for the animals.
• Adjust the height (see 1.1).
Have you checked all points and the brush still does not run:
• Switch off the brush at the switch for approx. 1 minute.
• After the waiting time, turn the brush on again and check for
proper operation
• If the brush still does not work after this check, contact your
service partner
If the brush constantly switches the direction of rotation, could:
• the brush be blocked
• dirt has accumulated on the bearing plate
• the gear unit is no longer in the correct position (e.g. due to
animal bounce)
SUEVIA HAIGES GmbH • Max-Eyth-Str. 1 • 74366 Kirchheim am Neckar • Deutschland • Tel. +49 7143 971-0 • Fax +49 7143 971-80
9. Additional safety instructions
IMPORTANT!
The KRAZZMAXX IV cow brush is intended solely for cleaning cattle and
cows in the dry.
Any other use results in the termination of warranty and general liability
of the manufacturer.
The SUEVIA HAIGES company accepts no liability for losses or damage
resulting from failure to adhere to these instructions or from inappropria-
te repairs by the operator's employees.
For repairs use only:
• Tools in proper working order
• Original spare parts
Caution
Risks for the animals:
1. The animals are not fully grown or they belong to a small breed of
cattle
2. If small animals are kept separately, the device can be positioned
correspondingly
3. The animals have collars which are too loose; collars must be snugly
fitting
4. The tail hair of the animals is too long.
not exceed 5 cm in
Risks for personnel handling the equipment:
Under the following circumstances, safety will be compromised:
1. When protective devices are removed
2. When unauthorized personnel manipulate electrical elements
3. When the machine is set in use when it is not properly mounted
4. When long hair, scarves and loose clothing can be drawn into the
brushes
EN 5/5
www.suevia.com • info@suevia.com • Stand: 01.06.2021
CAUTION:
All persons charged with the installation,
commissioning, servicing and maintenance
of the equipment must have the necessary
qualifications.
In the event that the machine has a fault, ensu-
re that it is not accessible to the animals. This
could otherwise result in additional damage to
the machine.
The cow brush starts immediately by rotating
the brushes, which brings with it the danger
of being caught up in and/or drawn into the
machine.
When operating the cow brush, please ensure
that you are at a safe distance and avoid wea-
ring loose clothing which could be caught up
in the machine. Protect your hair from being
caught up in the brushes.
(Trim the tails – the hair must
length)
Publicidad
