Publicidad
Idiomas disponibles
Idiomas disponibles
Content
1. Mounting instructions KRAZZMAXX IV
1.1 Determining the mounting height
1.2 Affixing the lifting harness
1.3 Affixing the cow brush
1.4 Checking the animal stock
1.5 Removing the transport protection
2. Operating instructions KRAZZMAXX IV
2.1 Power supply
2.2 Switching On/Off
2.3 Note concerning direction of rotation
2.4 Electrical protection class
2.5 Overrun time
3. Exchanging the brushes
3.1 Replacing the upper brush
3.2 Replacing the lower brush
4. Maintenance
5. Spare Parts list
6. Serial number and rating plate
7. Technical data
8. Troubleshooting
9. Additional safety instructions
1. Mounting instructions KRAZZMAXX IV
WARNING:
Do NOT reach in behind the protective cover
plate – there is a risk of serious injury!
Procedure:
1. Determine the mounting height for the cow brush: see Chapter 1.1,
Page 1.
2. The mounting surface must be planar. The wall must be adequate to
support the weight of the cow brush (129 kg).
3. Using a harness, suspend the cow brush from a front-end loader or the
like: see Chapter 1.2, Page 2.
4. Mount the cow brush: see Chapter 1.3, Page 2.
5. Remove the transport protection: see Chapter 1.5, Page 2.
6. If mounting on masonry, through bolts with large washers should be
used. For concrete walls, heavy-duty anchor bolts will normally be
adequate.
SUEVIA HAIGES GmbH • Max-Eyth-Str. 1 • 74366 Kirchheim am Neckar • Deutschland • Tel. +49 7143 971-0 • Fax +49 7143 971-80
1.1 Determining the mounting height
1
1
2
2
2
2
3
3
3
3
3
3
Figure 1: Hole pattern for mounting
3
3
Height of first hole (Pos. 1, see Figure 1) = shoulder height of the animal +
3
25 cm. For example, with a shoulder height of approx. 140cm (see Figure
4
2), the height of the first hole would be approx. 165cm.
Note: Determine the average shoulder height of the animals and, if in
4
doubt, mount the device 2cm higher.
5
5
5
5
Figure 2: Example for determining the mounting height
EN 1/5
www.suevia.com • info@suevia.com • Stand: 01.06.2021
Pos. 1
340 mm
Publicidad
