Publicidad
Idiomas disponibles
Idiomas disponibles
12. Air Conditioner Operations and Performance
The operating temperature range under which the unit runs stably are
given in below table.
Cooling mode
Indoor temperature
17～32
Indoor humidity
≤80%
(a) Condensation will form on the unit surface and water dripping
out of the unit when the indoor humidity is beyond 80%
Caution
•
The unit performs stably in the temperature range given in
above table. If the indoor temperature is outside the unit's
normal operating range, it may stop running and display an
error code.
To ensure the desired temperature is achieved efficiently, ensure that:
All windows and door are closed.
The airflow direction is adjusted to work in running mode.
The air filter is clean.
Please note how you can best save energy and achieve the best
cooling/heating effect.
Regularly clean air filters inside indoor units.
Check
regularly
Avoid too much outdoor air coming into air-conditioned spaces.
Note that outlet air is cooler or heater than set room temperature.
Avoid direct exposure to outlet air as it may be too cool or hot.
Heating mode
(DB)
15～27
°C
°C
(a)
Figure 12.1
Close doors and windows.
Figure 12.2
Do not set the
temperature too
low
Figure 12.3
Maintain a proper air distribution.Air outlet louvers should be used
to adjust the direction of outlet airflow, as doing so might ensure
more efficient operation.
(DB)
13. Adjusting Air Flow Direction
Since warmer air rises and cooler air falls, the distribution of
warmed/cooled air around a room can be improved by positioning the
unit's louvers. The louver angle can be adjusted by pressing the
[SWING] button on the remote controller.
Caution
•
During heating operation, horizontal airflow will aggravate the
uneven distribution of room temperature.
•
The louver direction: horizontal airflow is recommended
during cooling operation. Note the downward air flow will
cause condensation on the air outlet and louver surface.
Duct type
Use the following method to regulate the air outlet assembly (sold
separately).
1. Running in cooling Mode
In order to achieve the cooling effect at all parts of the room, adjust
the fan guide slider to the horizontal air outlet state.
2. Running in heating mode
In order to achieve the heating effect at the ground level of the
room, adjust the fan guide slider to the downwards air outlet state.
16
Figure 12.4
Figure 13.1
Figure 13.2
V.2
Publicidad
