Publicidad
Idiomas disponibles
Idiomas disponibles
SECURING THE SAFE
e safe must be secured to the floor.
NOTE:
Use the hardware provided or consult your
hardware retailer for fastening hardware for your
particular mounting surface.
is safe must be mounted to the floor.
NOTE:
Failure to do so will compromise the safety and
security of the safe.
Mark the holes to be used. Drill the appropriate
diameter and depth of pilot holes depending
on the type of hardware being used and the
type of mounting surface.
Secure the safe with the fasteners.
BACK UP KEY
A "Back Up Key" has been provided in case the
ba eries run low. If you lose your key, you may
purchase a replacement key be referencing the serial
number located on the back of your safe or the front
lower right corner. See section regarding
replacement keys for further information.
1. Remove the cover by pressing the tab and turning
the cover as shown in the illustration.
hang by the connecting cable while unlocking the
safe.
2. Insert the key in the key hole and turn clockwise
Lag screws
1/4 turn (until stopped) in order to unlock the safe.
Rotate the handle and open the door.
3. Keep the door open until you have entered a new
security code. Before entering your new code,
remove the key and screw the cover back in place.
BACK UP KEY
CLOCKWISE
1/4 TURN
e lock can
TAB
4
14
40677-2203
Publicidad
