Aube Technologies TH114-A Guía Para El Usuario página 12

Owner's Guide
Setting the configuration switches
Configuration switches are on the back of the faceplate.
# Configurations
S1 Displayed temperature unit
S2 Temperature control mode *
* See page 3 for definition of each mode.
- To select the F Mode, connect the floor temperature
sensor (see page 7) and place the switch in the F position.
- To select the AF Mode, proceed as follows: Connect the floor temperature sensor (see page 7).
Place the switch in the F position. If the thermostat displays Er, the sensor is improperly connected or
damaged. If the thermostat displays a temperature reading, place the switch in the AF position.
- o select the A Mode, place the switch in the AF position but do NOT connect the floor temperature
sensor.
Up Down
°F °C
F AF
10