Publicidad
Idiomas disponibles
Idiomas disponibles
Owner's Guide
Installing the thermostat
Turn the heating system off at the main electrical panel.
Loosen the bottom screw and remove the thermostat
faceplate from its wallplate. (The screw cannot be
completely removed.)
Wire the thermostat. See typical wiring on pages 8-9.
If the thermostat will be used in F or AF mode (see page 10),
connect the floor sensor (see page 7).
Install the wallplate on the wall using the provided screws
and wall anchors.
Set the configuration switches (see page 10).
Install the faceplate back on the wallplate and tighten the
screw. If there is a sticker on the screen, peel it off.
You can now return power to the heating system at the main electrical panel.
6
Faceplate
Wallplate
Publicidad
